• Convenient 6-hole ProtoBoard pattern provides an easy way to connect parts to IC’s.
• Good for analog op-amp circuits and digital logic layouts.
• Double-sided PCB with plated holes allows parts to be soldered on both sides.
• Rotated pattern allows edge parts to be located on the long edge.
• Square and round pads align with the square and round track ends to help position parts.
• High-quality double-sided FR4 glass-epoxy circuit board.
• 1oz/ft2 copper with an anti-tarnish coating for easy soldering. Lead free and RoHS compatible.
• 31 x 19 holes, 0.037" holes are drilled on 0.1" (2.54mm) centers. Four 0.125” mounting holes.
• Size1 = 50 x 80mm (1.97 x 3.15in), 1/16" thick (1.6mm)

The PR6H1-DR is a Size1 prototyping board with double sided (D) copper, a rotated pattern (R), and plated holes. The convenient 6-hole ProtoBoard pattern provides an easy way to connect parts to analog and digital IC pins. Either 3 or 4 holes are available at each IC pin for adding resistors, caps, and wires for a standard 0.3” wide DIP IC. It works well for analog op-amp layouts and digital logic circuits. It can be used with single in-line (SIL) sockets to allow development modules to be plugged in. Plated holes provide a stronger solder joint than with single-sided boards as the solder flows into the hole.

This double-sided board has 6-hole pads on the bottom side and individual pads on the top side allowing you to solder parts on either side as needed. Tracks only need to be cut on the bottom if shorter tracks or isolated pads are required. Positioning pads are provided to help in locating holes, with the bottom having square and round pads that correspond to the pads on the top side. The pattern is rotated 90 degrees so the tracks are parallel with the short edge of the board. This allows connectors, LEDs, and switches to be located on the long edge.

PR6H1-DR uses a high-quality FR4 glass-epoxy base that has higher stability and lifespan than vintage stripboard materials. An anti-tarnish coating protects the copper for a long shelf-life and provides easy soldering. The four 0.125" mounting holes are unplated to avoid shorting adjacent tracks in case they need to be used. They are sized for 4-40 size screws and are positioned on the 0.1” design grid.